Filter
Top Products
38
TANDBERG Videoconferencing SystemGeneral use
• Press ‘Add Site’ to bring up the MultiSite dial menu.
• Enter the number to call.
The Quality will, by default, be the same as used by the first call. To place a telephone call instead of a video call,
press ‘Quality’ and select ‘Teleph’ in the Quality menu.
To use another network operator, press ‘Net’ and select operator in the Net menu.
• Press CONNECT
connect
• Press CONNECT to bring up the following menu:
connect
Adding an extra site - dial out
First establish a normal point-to-point call. It is recommended to plan the bandwidth usage before making the first
call so that you do not run out of bandwidth.
EXAMPLE: IF THE SYSTEM HAS 512KBPS AVAILABLE AND YOU WANT TO CONNECT 3 SITES IN ADDITION TO THE HOST, 128KBPS SHOULD BE SELECTED
FOR THE FIRST CALL. THE SYSTEM WILL THEN AUTOMATICALLY USE 128KBPS WHEN CONNECTING THE OTHER SITES.
When the first site is connected, add a site to the conference using the following procedure:
IT IS POSSIBLE TO CONNECT SEVERAL TELEPHONES, E.G. 2 VIDEO SYSTEMS + 3 TELEPHONES (A TOTAL OF 5 SITES).
TIP
IF THE MULTISITE SYSTEM DOES NOT HAVE ENOUGH
BANDWIDTH
TO ADD ANOTHER SITE, THE SYSTEM
WILL
AUTOMATICALLY DOWNSPEED TO ALLOW AN
ADDITIONAL
SITE TO BE ADDED TO THE
CONFERENCE
. REQUIREMENT: FAR END MUST
SUPPORT
DOWNSPEED AND MUST HAVE ENOUGH
BANDWIDTH.
NOTE
CONNECT THE SYSTEM WITH THE LOWEST
BANDWIDTH
FIRST IN ORDER TO OPTIMIZE
CONNECTION TIME.
TIP