Filter
Top Products
- 16 -
Display Meaning
AWB OK Automatic white balance adjustment finished correctly.
AWB NG Automatic white balance adjustment cannot be performed because the video level
LEVEL LOW is too low.
Adjust the camera for a proper video level.
AWB NG Automatic white balance adjustment cannot be performed because the video level
LEVEL HIGH is too high.
Adjust the camera for a proper video level.
AWB NG OUT Automatic white balance adjustment cannot be performed because the color
OF RANGE temperature of the light source is out of the adjustable range.
If the message appears, change the illumination or use a color temperature
conversion filter.
AWB NG Automatic white balance adjustment cannot be performed for other reasons (such
as no white area is included in an object).
6.2.2 MANUAL (Manual white balance)
• Set the MODE to MANUAL on the WHT BAL setting screen. (Refer to the item “7.4 “WHT
BAL (White Balance)””)
• Shoot a white object, and adjust the white balance by adjusting R GAIN and B GAIN on
the setting screen while confirming with a monitor or a vector scope.
(Refer to the item “7.4.3 When Changing Settings in MANUAL (manual white balance
mode)”)
6.3 SCENE files
This unit has three SCENE files A, B and C selectable according to the shooting conditions.
• Select a scene set up on the OPTION screen (refer to the item 7.6 (2) “To change settings
of SCENE files”).
In this case, the set contents written into internal memory of this camera are loaded.
• After that, each time setting is changed on the screen display, the contents of the change
are written into memory and memorized even if the power source is turned off.
•To set SCENE files to factory setting status, press both the [MENU DOWN] and [DATA
DOWN] buttons at a time for approximately five seconds while the screen display and
color bar are turned off. The character “RESET OK” is displayed for approximately one
second, and the selected SCENE file is initialized to factory setting status.