Filter
Top Products
28
¾ Use the following DNS server address: Select this when you set the fixed IP address as the
IP address of DNS server.
z Primary DNS server: Enter the IP address of the primary DNS server.
z Secondary DNS server: Enter the IP address of the secondary DNS server.
)
Note:
1) PPPoE (Point-to-Point Protocol over Ethernet): PPPoE is a network protocol for
encapsulating Point-to-Point Protocol frames insider Ethernet frames. PPPoE connection is
used mainly with ADSL service where individual users connect to the ADSL transceiver
(modem) over Ethernet work. It also widely used in XDSL (digital affiliate line such as ADSL,
VDSL or SDSL)
2) The IP Camera needs to be rebooted after it finishes changing the network completely. For
more details, please refer to Section 6.1.3 Initialize.
3) The IP Camera with Intelligent IP Installer can’t be founded after PPPoE is active, but you
can get the IP address of the camera by IP Notification function. For more details, please
refer to Section 6.3.6 IP Notification
.
4) If the IP Notification function is not configured to report the IP address of the camera, you
can reset the camera to its factory default settings by pressing the Reset button. Then the
camera can be found by Intelligent IP Installer.
The change of settings will not take effect until the camera is rebooted. Please go to “System ->
Initialize” page and click the Reboot button as show in the figure below after you make some
changes.