TP-Link TL-SC3171 Security Camera User Manual


 
29
¾ Use the following IP address: Select this when the fixed IP address is set.
z IP address: Enter the IP address of the device.
z Subnet mask: Enter the subnet mask.
z Default gateway: Enter the default gateway.
¾ Use the following DNS server address: Select this when you set the fixed IP address as the IP
address of DNS server.
z Primary DNS server: Enter the IP address of the primary DNS server.
z Secondary DNS server (optional): Enter the IP address of the secondary DNS server if
necessary.
¾ HTTP port number: Select 80 in general situations. If you want to use a port number other than 80,
select the text box and enter a port number between 1024 and 65535.
z When you have set the HTTP port number to a number other than 80 on the Network setting
page or in the Setup Program, access the device by typing the IP address of the device on the
web browser as follows: for example, when HTTP port number is set to 2000 and the IP
address of your camera is set to 192.168.1.100, you should type in http://192.168.1.100:2000/
to access the device.
The change of settings will not take effect until the camera is rebooted. Please go to “SETTING
BASIC System Initialize” page and click the Reboot button as shown in the figure below
after you make some changes.