Uniden UDW-10003 Security Camera User Manual


 
19
Signal Level Icon Data Rate (kbps)
Frames per second (approx)
QVGA (Zoom) VGA (Normal)
Perfect 1062~1280 15~20 5~10
Good 725~1062 12~16 3~5
Fair 543~725 8~12 2~4
Low 250~543 0~5 0~1
Zero 0~250 0 0
If the suggestions above don’t provide enough improvement in the the signal quality, you may
want to run the camera at QVGA or zoom mode. When the camera is in zoom mode, it sends fewer
pixels to the receiver, so the video performance is not as affected by the weak signal.
Noise or Static
The most likely cause of noise (flickering image) or static is interference. There are many common
sources of interference:
electrical appliances, especially microwave ovens
computer equipment, especially wireless LAN equipment
other radio-based wireless devices, such as cordless telephones
wireless controllers, or wireless headphones or speakers
large florescent light fixtures (especially if they give off a buzzing noise)
working motors (hair dryers, heater/air conditioners, water pumps)