Uniden UDW-10003 Security Camera User Manual


 
7
Using the camera mount
The camera has a built-in stand so you can place it on any flat
surface. If you want to place your camera on a wall or a ceiling (or
even if you just want to secure it to a flat surface), you can use
the included camera mount.
(You might want to bring the receiver along when you mount
the camera; it’s much easier to get the the camera into the right
position when you have the display handy.)
Hold the base of the mount where you want to attach it, and
mark the location of the screw holes.
Use the included screws and anchors to attach the base to the
wall or ceiling.
Attach the camera to the mounting screw. Tighten it a few
turns, then turn it to the direction you want.
Tighten the camera brace up
against the back of the camera to
secure it into place.
Unlock the mounting post by
turning the wingnut to the left a
few turns.
Set the mounting post to the
correct angle, then tighten the
wingnut until the post is locked
into place.
1.
2.
3.
4.
5.
6.
Camera
brace
Mounting
screw
Mounting
post
Post
lock
Screw
holes
Camera
brace
Mounting
screw
Mounting
post
Post
lock
Screw
holes
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.