ViewSonic VS14315 Camcorder User Manual


  Open as PDF
of 50
 
7
Section 2
Getting Started
Loading the Battery
Before using the camcorder, you must load the Lithium-ion
rechargeable battery come within the package.
1. Insert the battery according to the correct polarity marks ( + or -).
2. Close the battery cover rmly.
Charge your battery
You must use the supplied AC charger or the USB cable. The camcorder
must be turned OFF. The blinking light conrms the camcorder is currently
charging, and the light becomes constant after the charging is completed. In
AC charging Mode, the light will turn itself off automatically after 3~5 minutes
. The full charge time is about 4 to 5 hours. (Actual charging time may vary. It
depends on the battery conditions.)
Inserting and Removing an SD Card (Optional)
The camcorder comes with an internal memory that allows you to store photos and videos. You can
expand the memory capacity by using an optional SD memory card.
1. Insert the memory card into the slot. Please refer to the gure on
the right side.
2. To remove the installed SD card, press the card inward to release it.
3. When the card pops out, gently remove it from its slot.
4. Recommended memory capacity: 1GB or above.
Note
• When a memory card is tted, videos/photos are saved to the card rather than the built-in
memory.
• ProtectingDataonanSDCard:SDCardisread-onlywhenitislocked.Nophotosorvideoscan
berecordedwhentheSDcardislocked.Makesure
thelockisonthewriteablepositionbeforerecording
anymedia.
Writeable
position
Write-Protected
Position
 previous next