Filter
Top Products
VIVOTEK
User's Manual - 9
First, use the included T20 hex key wrench to loosen the four screws and detach the dome
cover from the camera base� Follow the steps below to install the camera either to a ceiling or a
wall�
Top View
Dome Cover
Dome Cover Retainer
IMPORTANT! Dome cover should be removed because if it should fall during the instal-
lation process, physical injury could occur to your co-workers�
Connect power lines and if you have external devices such as sensors and alarms, make the
connection from the general I/O terminal block�
Cabling Assembly
For Ethernet Cable
For Power & IO Cables
Top View
Power and IO cables pass through a waterproof
connector� The Ethernet cable should be routed
through a rubber seal plug� All cables are user-
supplied�
Hardware Installation
Removing Dome Cover