Vivotek FD8162 Security Camera User Manual


 
VIVOTEK
User's Manual - 7
Hardware Installation
Use the included T10 Torx screwdriver to loosen screws on the sides of dome cover to remove it You
should then jot down the MAC address printed on the bottom of the camera�
Remove the black cover as shown below so that you can ne-tune the focus and zoom the
camera later when the cabling is done�
50
50
5m
41
41
5m
Before installing your camera, make
sure the built-in PIR (Passive Infrared
Sensor) can be directed toward the
area of interest, where possible
intrusion may occur (The sensitivity
of PIR sensor depends on the object
size and temperature differences
between the object and the background
environment�)
Dome Cover
Dome Cover
Bottom of the Camera
Tilt Adjustment
Screw
Focus Ctrl
Zoom Ctrl
Top View
Side View