Filter
Top Products
- 19 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
to allow a transmission rate of greater than 20 image frames per second. If the
broadband network is over 1 Mbps, set the “Fix bit rate” to 1000Kbps or 1200Kbps, or
set “Fix quality” at the highest quality. The maximum frame rate is 25 fps in a 50Hz
system and 30 fps in a 60Hz system. If your network bandwidth is more than 384Kbps,
you can fix the bit rate according to your bandwidth and set the maximum frame rate
to 25 fps or 30 fps. If you are shooting fast-moving images, you may want to slow the
maximum frame rate down to 20 fps in order to lower the rate of data transmission.
This allows for better video quality and the human eyes cannot readily detect the
differences between those of 20, 25, or 30 frames per second. If your network
bandwidth is below 384 Kbps, set the “Fix bit rate” according to your bandwidth and try
to get the best performance by fine-tuning with the “Maximum frame rate”. In a slow
network, greater frame rate results in blur images. Another work-around is to choose
“Half” in the “Size” option for better images, or “Halfx2” for a larger image view. Video
quality performance will vary somewhat due to the number of users viewing on the
network; even when the parameters have initially been finely tuned. Performance will
also suffer due to poor connectivity because of the network’s burst constraint.
In multi-user environment, the user who has poor network performance will receive
only the key frame in MPEG4 format. Try to reduce the key frame interval can improve
the frame rate for poor network performance, but the penalty is the increasing of
network traffic. If the server is running on the Internet, select the “improve efficiency
in the multi-user environment” will improve the efficiency in the multi-user
environment.
Only Quality Images Will Do
To have the best video quality, you should set “Fix quality” at “Detailed” or “Excellent”
and adjust the “Maximum frame rate” to match your network’s bandwidth. If your
network is slow and you receive “broken” pictures, go to the HTTP protocol in
“Connection type” and choose a more appropriate mode of transmission. The images
may suffer a time delay due to a slower connection.
Somewhere Between Real-time and Clear Images
If you have a broadband network, set “Fix quality” at ”Normal” or better, rather than
setting “Fix bit rate”. You can also fix the bandwidth according to your actual network
speed and adjust the frame rate. Start from 30 fps down for best results
but not below 15 fps. If the image qualities are not improved, select a lower bandwidth