Filter
Top Products
154
MVP MANUAL
(3) Bright compensation [BRT command]
Input: BRTd
Explanation: Corrects the brightness of the NTSC input board.
d : Compensation value 0 to F
*
BRTd
: Displays the current value and moves to the sub command mode
• To execute this command, it is necessary to set the adjustment mode by AJYC. (Refer to the
AJYC command.)
• The changed value will be memorized the last.
(Example) BRT3 Sets the bright level to 3.
*Sub command mode of BRT command
The sub command mode is set by BRT
.
(Example) BRT3
*
* indicates the current value.
Input + and – at the cursor position.
Always input
(CR) to end.
(4) Color compensation [COL command]
Input: COLd1d2d3
Explanation: Corrects the color of the NTSC input board.
d
1d2d3 : Compensation value 0 to 255
COL?
: Help display
COL
: Displays the current value and moves to the sub command mode
• To execute this command, it is necessary to set the adjustment mode by AJYC. (Refer to the
AJYC command.)
• If data input is skipped, the sub command input mode is set after the data is displayed.
COL sub command mode
The COL sub command mode is set by COL
.
(Example) COL
***
*** indicates the current value.
Input the following sub command at the cursor position.
Always input
(CR) to end.
0 to 255
: Ends the sub command mode after a number has been input.
+, – : Increases/decreases the data by one step.
UP1 to 9, 0 : Increases the current data by 1 to 10 steps.
DW1 to 9, 0 : Decreases the current data by 1 to 10 steps.
RES : Defaults the adjustment value (factory setting).
: Ends the sub command input mode.
• The changed value will be memorized the last.
(Example) COL
UP0 : Increases the color compensation value by 10 steps.