Filter
Top Products
158
MVP MANUAL
9. INSTALLING AND REMOVING BOARDS
(Fig. A)
(Fig. B)
(Fig. C)
Screw (3x6)x6
<Removal procedure>
1 Remove the front panel.
2 Remove the screws fastening the board to the
removed. (Fig. C)
3 Lift the ejectors indicated with white arrows. (Fig.
B)
4 Gently draw out the board along the rails.
5 Set the front panel back in place.
For your safety
¶ Be sure to turn the power off before installing
and removing boards.
<Installation procedure>
1 Remove the screws from the front panel, then
open the front panel. (Fig. A)
2 Insert the board gently along the rails.
Refer to the board layout for the positions for in-
serting the boards.
3 Press the
part of the white plastic part
strongly with a finger and insert the board fully
to the back. (Fig. C)
* The board may not go fully to the back if pressed
on the metal part.
4 Fasten with the flanged screws (3x6). (Fig. C)
5 Set the front panel back in place.