Filter
Top Products
NetCamera NV
Address of the IP Security Night Vision Camera is within the
same subnet as your workstation.
Click “Start”, “Setting”, “Control Panel”, and the “Network” icon.
Select TCP/IP from the “Network” dialog box and from the
“TCP/IP Properties” dialog box click “Specify an IP address”.
If the IP Security Night Vision
Camera is situated on a different
subnet than your workstation, you will not be able to set the IP
address from this workstation. To verify make sure the first 3
sections of the IP address of the IP Security Night Vision
Camera corresponds to the first 3 sections of the workstation.
Therefore the IP address of the IP Security Night Vision
Camera must be set from a workstation on the same subnet.
Question I cannot access the IP Security Night Vision Camera from
a web browser.
Answer
Other possible problems might be due to the network cable.
Try replacing your network cable. Test the network interface
of the product by connecting a local computer to the unit,
utilizing a standard Crossover (hub to hub) Cable. If the
problem is not solved the IP Security Night Vision
Camera
might be faulty.
Question Why does the Power LED not light up constantly?
Answer
The power supply used might be at fault. Confirm that you are
using the provided power supply DC 5V for the IP Security
Night Vision
Camera and verify that the power supply is well
connected.