Filter
Top Products
50
AXIS 225FD - Unit Connectors
Power connections
Power can be supplied to the camera by the following methods:
• PoE (Power over Ethernet) via the network cable. This
will automatically be detected if
available via the network. Note that PoE only provides power for the camera and the
fan (not the heater).
• Connect the supplied indoor power adapter to
the power connector block in the camera
casing. Note that this indoor power adapter only provides power for the camera and
the fan (not the heater).
• Connect an outdoor power supply to
the power connector block in the camera casing.
For information on available outdoor power supplies, please visit the Support pages at
http://www.axis.com/techsup/
Power Connector Block
The power connector block supports both
AC and DC input power.
The DC supply is 9-24V. Connect the negative pole to the GND pin and the positive pole to
th
e DC+ pin.
The AC supply is 10-24V. Connect the AC
poles to the AC pins.
Power connector block pin assignment table.
Pin Function
GND Ground/DC-
AC/DC+ AC and DC+, power input for mains power to unit
AC AC power input for mains power to unit
AC
AC
DC+
GND