Filter
Top Products
7
AXIS 225FD - Product Features
Power connector block - for connection of a power supply. See Power connections, on
page 50.
I/O terminal connector - The I/O terminal connector pro
vides the physical interface to one
solid state relay output, two digital inputs, RS-485/422 and GND. For more information,
see Unit Connectors, on page
47.
Network connector
- The AXIS 225FD connects to the network via a standard network
cable, and automatically detects the speed of the local network segment
(10BaseT/100BaseTX Ethernet). This socket can also be used to power the AXIS 225FD via
PoE (Power over Ethernet). The camera also negotiates the correct power level when using
PoE.
Serial Number - This number is used during installation.
Control Button
- This button is used during the installation using the AXIS Internet
Dynamic DNS Service (see the Installation Guide) or to restore the factory default settings,
as described in Advanced, on page 45.
LED Indicators
After completion of the startup
and self test routines, the multi-colored Network, Status,
Heater, and Power LED indicators flash as follows:
Green Steady for connection to 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 1
0 Mbit/s network. Flashes for network activity.
Red Flashes rapid red, together with the S
tatus indicator, for hardware error.
Unlit No connection.
Green Shows steady green if the connected power sup
ply can deliver the correct voltage for
the heater (See Power, on
page 58 of Technical Specifications).
Red Shows steady red if the connected power supply can
not deliver the correct voltage (i.e.,
the voltage is either too high or too low).
Green Shows steady green for normal operation. Can be c
onfigured to flash green at intervals
whenever the camera is accessed. See the online help for more information.
Amber Shows steady amber during reset to factory
default or when restoring settings.
Red Slow flash for failed upgrade (see Emergenc
y Recovery Procedure, on page 44).
Rapid flash, together with the Network indicator, for hardware error.
Unlit When configured for “no flash” on camera access.
Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
Network
Heater
Status
Power