Filter
Top Products
28 en | Installation FlexiDome2X IP Camera
AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual Bosch Security Systems
2. Remove the trim ring with dome by pulling it off of the
base.
3. Remove the inner liner by pulling it off of the base.
4. Remove the pink protection foam.
5. Loosen the three Phillips screws. Remove the single screw
holding the camera module in place (no keyhole).
6. Rotate the camera module to remove it from the remaining
two screws.
5.1.2 Flush mount version
The camera/housing unit consists of the following parts:
To disassemble the unit proceed as follows:
1. Using the special screwdriver bit, loosen the three tamper-
resistant screws in the trim ring (the screws remain in
place).
2. Remove the trim ring with dome by pulling it off of the
base.
3. Remove the inner liner by pulling it off of the base.
1. Camera module and mounting base
2. Inner liner (with sealing ring)
3. Dome
4. Trim ring