Filter
Top Products
FlexiDome2X IP Camera Advanced Mode | en 73
Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
A low (negative) value means that the camera switches to
monochrome at a lower light level. A high (positive) value
means that the camera switches to monochrome at a higher
light level.
Priority
In Auto switching mode, set the camera priority to either:
– Color: the camera gives color pictures as long as the light
level permits.
– Motion: the camera gives sharp images without motion
blur as long as the light level permits (it switches to
monochrome earlier than it would with Color priority).
The camera recognizes IR-illuminated scenes to prevent
unwanted switching to color mode.
IR contrast
There are two modes for IR contrast:
– Enhanced: the camera optimizes contrast in applications
with high IR illumination levels. Select this mode for IR
(730 to 940 nm) light sources and for scenes with grass
and green foliage.
– Normal: the camera optimizes contrast in mono
applications with visible light illumination.
Color burst
– Off: the color burst in the video signal is switched Off in
monochrome mode.
– On: the color burst remains active even in monochrome
mode (required by some DVRs and IP encoders).
9.6.5 Enhance
Dynamic engine
– Off: turns off all automatic scene detail and enhancements
(only recommendedfor testing).
– XF Dynamic: extra internal processing is enabled for low-
light applications (traffic, etc.).
– 2X Dynamic: 2X Dynamic adds dual sensor exposure to the
XF Dynamic features. In harsh lighting conditions pixels