Filter
Top Products
34 en | Configuring the System High Speed Pan/Tilt System
F01U.073.990 | Version 1.0 | 2007.07 Instruction Manual Bosch Security Systems
10.2 Changing the Settings
To change a setting, proceed as follows:
1. AUX ON - 200 - Enter to enable the OSD.
2. Move the cursor to the parameter to be changed.
3. Press the confirmation (Focus) button. The field starts flashing, indicating that it is in
change mode. Operating the joystick (up and down) shows the alternative choices.
4. After identifying the desired selection, press the confirmation (Focus) button; the param-
eter stops flashing.
Note: For UPH-2D and UPH-3D Series (Dinion
XF
) models, use up and down to scroll through
the menus, Focus to enter a submenu, and left and right to change values.
10.3 Changing the Numeric Fields
To change a numeric field, proceed as follows:
1. Use the joystick to scroll to the parameter you would like to edit.
2. Press the confirmation (Focus) button. The cursor starts flashing for the character to be
changed, indicating it is in edit mode.
– The minimum and maximum values allowed are displayed at the bottom of the
screen. If you try to insert a value outside the limits, the field is forced to the mini-
mum or maximum allowed value.
– Operating the joystick (up and down) shows the alternative choices. If there is more
than one field on the same line, it is necessary to select the field by moving the joy-
stick (left and right).
3. After making the change, press the confirmation (Focus) button.
– The first digit in the numeric field to be changed flashes and the last line of the dis-
play shows the accepted limits for the field.
– Move within the field (left and right) and change the sign or the numeric value (up
and down).
Note: For UPH-2D and UPH-3D Series (Dinion
XF
) models, use up and down to scroll through
the menus, Focus to enter a submenu, and left and right to change values.
11 Configuring the System
The UPH High Speed Pan/Tilt can be configured through the on-screen display (OSD). Open
the main menu by pressing AUX ON - 200 - Enter.
MAIN MENU
1 - LANGUAGE
2 - DISPLAY SETUP
3 - MOTION PARAMETERS
4 - CAMERA PARAMETERS
5 - LOAD DEFAULT CONFIGUR.
6 - SETUP INFO
Fig. 11.1 OSD (On-screen Display) Main Menu