Filter
Top Products
57
3 Setting the Image-recording Quality
Set the ISO speed (image sensor’s sensitivity to light) to suit the
ambient light level. In the fully-automatic modes (1/C), the ISO
speed is set automatically (p.58).
1
Press the <m> button. (9)
2
Set the ISO speed.
While looking at the LCD panel or
viewfinder, turn the <6> dial.
It can be set within ISO 100-6400 in
1/3-stop increments.
With “A” selected, the ISO speed will
be set automatically (p.58).
The maximum burst is displayed even when a card is not in the camera.
Make sure that a card is loaded before taking a picture.
If [8C.Fn II -2: High ISO speed noise reduction] is set to [2: Strong],
the maximum burst will be greatly reduced (p.195).
If the viewfinder displays “99” for the maximum burst, it means the
maximum burst is 99 or higher. If 98 or lower is displayed, the maximum
burst is 98 or lower. If you stop the continuous shooting, the maximum
burst will increase. After all the captured images are written to the card,
the maximum burst will be as listed on page 55.
The maximum burst indicator in the viewfinder will not change even
when you use a UDMA CF card. However, the maximum burst shown in
parentheses on page 55 will apply.
i: Setting the ISO SpeedN
COPY