Filter
Top Products
62
3 Setting the Image-recording Quality
The RAW image is the data output by the image sensor and converted
to digital data which is recorded on the card as is. You can select it from
among 1, D1, or D2. “RAW” written in the text will refer to
all three RAW settings: 1, D1, and D2.
With RAW images, you can use the provided software to make various
adjustments as needed. From the RAW image, the software can
develop and produce the adjusted image in the desired type such as
JPEG or TIFF.
The maximum burst during continuous shooting indicated on the
preceding page is the number of continuous shots that can be taken
without stopping, based on a formatted 2GB card.
The number is displayed in the
viewfinder on the bottom right. If the
maximum burst is 99 or higher, “99” will
be displayed.
About RAW
Maximum Burst During Continuous Shooting
About [8C.Fn II -2: High ISO speed noise reduction] and
RAW or RAW+JPEG images
Although [8C.Fn II -2: High ISO speed noise reduction] (p.176) settings
(Standard/Low/Strong/Disable) are applied to the recorded images, the
images without noise reduction applied are used during image playback (on
the LCD monitor and on a TV screen) or direct printing. (Noise may appear
in the images.)
Confirm the noise reduction effects or print noise-reduced images with
Digital Photo Professional (provided software).
Commercial software might not be able to display RAW images. Using the
provided software is recommended.
COPY