Filter
Top Products
119
E
Using a Memory Card
(MV4i MC only)
4. Select the desired setting.
• Your currently recording image is combined with the pre-recorded still
image.
5. Select MIX LEVEL.
6. Adjust the mix level.
• Turning the SELECT dial upwards adjusts to the right and turning
downwards adjusts to the left.
7. Close the menu.
• CARD MIX flashes in the display.
8. Press the MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still
image.
• Each time you press the MIX button, your selection is activated (display
lights continuously) or deactivated (display flashes).
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the cassette.
1. Press the PHOTO button halfway down and hold it.
• F flashes white in the display as the camcorder adjusts the focus and it is
displayed continuously as a green mark when the camcorder is ready to take
the image.
2. Press the PHOTO button fully down to record the image to the
cassette.
• F disappears from the display.
• The combined images are recorded onto the cassette for approximately 6
seconds (8 seconds in the SP or LP recording mode).
• You can not use Card Mix in the Low Light recording program (in MOVIE and
P.SCAN modes).
• If you change the position of the POWER dial or move the program selector
from
Q
to
[
Easy Recording mode, select your still image for Card Mix again.
• When setting Card Mix, you must carry out steps 1 to 5.
For a still image
For a moving image
On/Off
#5_MV4/MV4 MC-i_E(98-125) 01/7/31 10:34 Page 119 (1,1)