Canon MV530i Camcorder User Manual


 
57
E
Using the Full
Range of Features
If the subject is unsuitable for autofocus ( 143), the camcorder may not
be able to focus, and
F
may continue to flash white in the display. Continue
to hold the PHOTO button halfway down, then adjust the focus manually
with the selector dial.
If you are using manual focus ( 79), the
F
mark starts as a continous
green mark. Focus with the selector dial.
2. Press the PHOTO button fully down to take the still picture.
The camcorder takes the image immediately, and then records the photo to
the tape for approximately 6 seconds*. During this time the camcorder also
records the sound, and the display shows the still picture.
A counter display appears, and counts up as the camcorder records the
picture.
F
disappears from the display.
The camcorder returns to record pause mode.
Notes:
The camcorder automatically returns to record pause mode after recording a
still image for approximately 6 seconds*. If you turn the POWER switch to
OFF during that time, the camcorder will respond only after recording is
complete.
The wireless controllers PHOTO button has no half-way setting. Press the
button fully and the camcorder immediately takes the photo.
Only take photos where it is bright enough to see the image in the display.
* 8 seconds in SP or LP recording mode.
MV550i
#3_ MV550i/530i__E(39-86) 1/9/02 14:49 Page 57