Filter
Top Products
78 Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus
To abort the data recording while in progress
Press the DOWN/OFF button.
After the data has been recorded, the following display
appears.
Viewing SetupLog Data
1 Connect the DSR-1/1P and load the tape that
contains the recording to be viewed. Turn the
camera power on.
2 Play back the tape.
For details of playback operation, see the operating
instructions for the DSR-1/1P.
3 Press the MENU/STATUS switch up to the
STATUS side.
The display changes to page 1 of the status display.
PLAY
TCR 12:34:56:00
SETUP LOG 1/3
W:A
WHITE : A 3200
A.IRIS : STD
FILE : STD
F5.6
DCC+ : ON
0dB
SKIN DTL : OFF
3200
Each time you press upward the MENU/STATUS
switch, the status display cycles through the status
pages and playback display in the order: page 2,
page 3, the playback display (containing the
current settings), and page 1.
Status display (page 2)
PLAY
TCR 12:34:56:00
SETUP LOG 2/3
W:A
A.IRIS : ± 0
DTL LEV : ± 0
M.BLACK : ± 0
F5.6
STRETCH : ± 0
0dB
SS :1/100
3200
Status display (page 3)
PLAY
TCR 12:34:56:00
SETUP LOG 3/3
W:A
M.GAMMA : ± 0
V DTL LEV: ± 0
DTL FREQ : M
F5.6
SKIN SAT : ± 0
0dB
SKIN HUE : ± 0
3200
SAT : ± 0
HUE : ± 0
Notes
• SetupLog data is not recorded while SetupNavi data
or a setup file is being recorded onto a tape. (If you
play back a tape containing SetupNavi data or a setup
file, the data displayed in the setup display is not the
SetupLog data of the playback picture.)
• In the following cases, changed settings that were not
recorded may appear as blank settings.
– SetupLog data is overwritten at intervals of a few
seconds during recording. If the settings are
changed frequently for certain items, it may not
always be recorded in time.
– If the recording time is very short, recording may
be ended before all of the data has been
overwritten.
Settings during
recording
Using SetupNavi and SetupLog with the DSR-1/1P