Filter
Top Products
Trouble?
49
Additional Information
Editing
List of Messages
No sound from the built-in
speaker.
Open the LCD panel. –
Speaker volume is turned off. Adjust the volume with the
[SPEAKER VOLUME] setting.
23
Image will not appear on the
TV screen.
Check again that the camcorder is properly connected to the TV. 40
Tape is running, but image will
not appear on the TV screen.
TV/VIDEO selector on the TV is not set to VIDEO. Set the
selector to VIDEO.
42
Video heads are dirty. Clean the video heads. 2
You attempted to play back or dub copyright a protected tape.
Stop playback/dubbing.
43
Problem Solution
Cannot record with this
camcorder video input from an
external video device
connected using a DV cable.
Wrong signal standard. Refer also to the instruction manual of
the connected device.
–
Message Explanation/Solution
SET THE TIME ZONE,
DATE AND TIME
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
19
CHANGE THE BATTERY
PACK
Battery pack is exhausted. Replace or charge the battery pack. 13
THE TAPE IS SET FOR
ERASURE PREVENTION
Cassette is protected. Replace the cassette or change the position
of the protect switch.
52
REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove the
cassette and reinsert it.
15
CHECK THE INPUT
The DV cable is not correctly connected to the DV terminal, or the
connected digital device is turned off.
40
The video input signal is in a different television system (NTSC). –
CONDENSATION HAS
BEEN DETECTED
Condensation has been detected in the camcorder. 54
CONDENSATION HAS
BEEN DETECTED
REMOVE THE CASSETTE
Condensation has been detected in the camcorder. Remove the
cassette.
54
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
INCORRECT TAPE
SPECIFICATION
You attempted to play back a tape recorded in a different television
system (NTSC) or in a recording standard not supported by this
camcorder.
–
Problem Solution