Filter
Top Products
Flex TEST button
Reset
The MiniTT1 and FlexTT5 can be reset in the eld.
There are two types of reset.
RESET A: Returns both C.1 and C.2 to the channels you last set
in the PocketWizard Utility. Reset A is primarily used for resetting
channels that were taught in the eld.
1. Turn the radio off
2. While holding TEST, slide the power switch to C.1 (C.1 and C.2
are always reset together).
3. Hold TEST for a few moments until you see 2 green blinks, then release TEST. The channels
are restored to their last Utility values. If you’ve never set the channels using the Utility, then
the channels are restored to factory defaults.
RESET B: Returns all of your radio’s settings, including channels and all settings from the
PocketWizard Utility, to factory defaults.
1. Turn the radio off
2. While holding TEST, slide the power switch to C.1 (C.1 and C.2 are always reset together).
3. Hold TEST for ~10 seconds until you see 4 green blinks, then release TEST. The radio is reset
to factory defaults.
Default Settings:
ControlTL Tx Channel = 1 HyperSync Offset = -170
Standard Tx Channel = 1 Remote TTL Flash Sleep Delay = Disabled
Use ControlTL for Rx Channel = Enabled Flash Idle Time Out Mode = Disabled
ControlTL Rx Channel = 1 Force TTL Master Mode = Disabled
Camera Model = Auto Bottom Shoe = Enabled
28