Filter
Top Products
2-4
1. Set Up the Camera
a WARNING:
Install the camera securely.
● When installing the VB-C50Fi on the ceiling or a wall, contact your Canon dealer.
● When installing the VB-C50Fi on the ceiling or a wall, check that it is strong enough to
bear the weight of the VB-C50Fi including the mounting arm. Installation in a weak location
could result in the VB-C50Fi falling and causing serious injury. Check that the ceiling can
hold either 3 times the weight of the camera and arm or 8kgs (whichever is heavier) for 1
minute.
● When attaching the arm to the ceiling, make sure that the screws are tightly fastened.
The arm and camera may fall if the screws are not tightly fastened, which may cause
serious injury.
● At least once a year, check for looseness in the camera installation mount. (If the optional
wide converter is used, check the converter mount also).
● Do not install the arm in a place that shakes or vibrates frequently as the screws may
come loose causing the camera to fall or be damaged, which in turn may cause serious
injury.
Note
● The MAC address required when making network settings is shown on the rear of the
VB-C50Fi (→ P.1-9). Please make a note of it before installing this unit (→ P.2-8).
● Always use a tripod mounting screw that is less than 6.0 mm (
1
/
4
in.) in length. The
use of screws 6.0 mm (
1
/
4
in.) long or longer could damage the camera. Also, the
tripod seat used should be at least 30 mm (1
3
/
16
in.) in diameter.
Firstly, set up the camera. Read the following carefully and make sure the camera is set up properly.
Mounting
screw
Less than
6.0 mm
(
1
/
4
in.)
30 mm
(1
3
/
16
in.)
or wider
Mounting the Camera to the Ceiling or Wall
Attach a mounting arm (not included) to the ceiling or a
wall and firmly attach the camera to the arm.
When Using a Tripod