Filter
Top Products
BASIC IMAGE RECORDING
60
Changing the Flash Intensity Setting
Perform the following steps to change the flash intensity
setting.
1.
In a REC mode, press [MENU].
2.
Use [̇] and [̈] to select the “ REC” tab.
3.
Use [̆] and [̄] to select “ Flash Intensity” ,
and then press [̈].
4.
Use [̆] and [̄] to select the setting you
want, and then press [SET].
Using Flash Assist
Recording a subject that is outside the flash range can
cause the subject to appear dark in the resulting image,
because not enough of the flash reaches the subject. When
this happens, you can use flash assist to correct the
brightness of the recorded subject, so it appears as if the
flash illumination was sufficient.
IMPORTANT!
• Flash intensity may not change if the subject is too
far or too close to the camera.
To make flash intensity:
Stronger
Normal
Weaker
Select this setting:
+2
+1
0
–1
–2
disp
1.
In a REC mode, press [MENU].
2.
Use [̇] and [̈] to select the “ REC” tab.
3.
Use [̆] and [̄] to select “ Flash Assist” , and
then press [̈].
disp
Flash assist used Flash assist not used