Filter
Top Products
37
BASIC IMAGE RECORDING
Using the Flash
Perform the following steps to select the flash mode you
want to use.
1.
In the REC mode, press MENU.
2.
Rock the controller left or right to select the
“REC” tab.
3.
Rock the controller
up or down to select
“Flash”, and then
rock the controller to
the right.
4.
Rock the controller up or down to select the
flash mode you want, and then click.
5.
Record the image.
IMPORTANT!
• The flash unit of this camera fires a number of times
when you record an image. The initial flashes are pre-
flashes, which the camera uses to obtain information it
uses for exposure settings. The final flash is for re-
cording. Make sure that you keep the camera still until
the shutter releases.
• Image recording may not be performed if you press
the shutter release button while the operation/flash
charge lamp is flashing amber.
To do this:
Have the flash fire automatically
when required (Auto Flash)
Turn off the flash (Flash Off)
Always fire the flash (Flash On)
Fire a pre-flash followed by image
recording with flash, reducing the
chance of red-eye in the image (Red-
eye reduction)
Select this setting:
Auto