Filter
Top Products
Operation Instructions Tool Inspection
17
breakage and any other condition which may affect its operation.
204BUse only accessories that are recommended by the manufacturer
for the tool.
205BDry your hands before operating the tool or charging the battery.
206BAlways use appropriate personal protective equipment while
handling and using the tool. Appropriate personal protective
equipment always includes safety glasses and gloves, and may
include latex or rubber gloves, face shields, goggles, protective
clothing, respirators and steel toed footwear.
Protect against excessive heat. The tool should be kept away
from heat sources such as radiators, stoves or others products
that produce heat. Do not use the tool near moving machinery or
areas where the temperature will exceed 113°F (45°C).
209BStore the tool, charger and all cables in a locked area out of the
reach of children and people unfamiliar with the tool.
23B5.3 Tool Inspection
210BWARNING: Before using, inspect your tool and correct any
problems to reduce the risk of serious injury from electric shock and
other causes and to prevent damage to the tool.
211BMake sure the power is OFF.
212BClean any oil, grease or dirt from the tool, especially on the
buttons and ports. This helps to prevent the tool from slipping
from your hands.
213BInspect the imager head lens for condensation. To avoid
damaging the tool, do not use the tool if condensation forms
inside the imager head. Let the water evaporate before using
again.
214BInspect the full length of the cable for cracks or damage. A
damaged cable could allow water to enter the tool and increase
the risk of electric shock.
215BMake sure the connections between the display unit and imager
head and cable are tight. All connections must be properly
assembled for the cable to be waterproof.
216BCheck if the warning label is present, firmly attached and
readable. Do not operate the tool without the warning label.