Filter
Top Products
Operation Instructions Tool and Work Area Set-Up
19
Check if any liquids will be contacted during inspection.
The imager head and cable are waterproof to a depth of 3m
(10'). Greater depths may cause leakage into the imager
head and cable and cause electric shock or damage the tool.
The display unit is not waterproof and should not be
exposed to wet conditions.
Check if any chemicals are present, especially in the case of
drains. Chemicals may damage the tool.
Check the temperature of the area. The working temperature
of the tool is between 32°F (0°C ) and 113°F (45°C).
Check if any moving parts are present in the area.
3) 237BMake sure the tool has been properly inspected.
4) 238BInstall the correct accessories for use in the appropriate
application.
239BCAUTION: Make sure the tool has been powered off before
performing maintenance.
240BTool maintenance must be performed only by qualified repair
personnel. Maintenance performed by unqualified repair
personnel could cause injury.
241BWhen maintaining, use only identical replacement parts. Use of
unauthorized parts or failure to follow maintenance instructions
may create a risk of electric shock or injury.
242BDo not attempt to take any pieces of the tool apart unless directed
by the manual.
243BFollow instructions to change accessories.
244BDo not use acetone to clean the tool. Instead, use only alcohol to
swab the connections. Avoid rubbing too hard on the LCD
screen. After using, wipe the display unit clean gently with a dry
cloth.
245BUpon the completion of any maintenance of the tool, ask
qualified repair personnel to perform safety checks to examine if
the tool is in proper operating condition.
246BStop using the tool if it starts smoking or emitting noxious
fumes.
247BAlways handle the tool with care. It is not shock-resistant.
Do not disassemble the tool beyond what is shown in the manual.
Doing so will void your warranty.