Filter
Top Products
Operation Instructions Tool and Work Area Set-Up
18
Turn on the power and make sure the tool starts up as described
in the Basic Operation section.
218BIf the tool does not work well after turning it on, have the tool
checked by a qualified technician. Any tool that cannot be
controlled with the power button is dangerous and must be
repaired.
219BNOTE: Please check following methods to avoid injury.
220BFOR WALLS: For inspecting inside walls, shut off the circuit
breaker to the whole house before using the tool.
FOR PIPES: If you suspect a metal pipe could contain an
electrical charge, have a qualified electrician check the pipe
before using.
222B FOR AUTOMOBILES: Be sure the automobile is not running
during inspection. Metal and liquid under the hood may be hot.
Do not get oil or gas on the imager head.
24B5.4 Tool and Work Area Set-Up
223BCAUTION: Set up the tool and work area according to these
procedures to reduce the risk of injury from electric shock,
entanglement, and other causes and prevent tool damage.
1) 224BCheck work area for:
225BSufficient lighting.
226BDo not work in an area until flammable sources have been
identified and corrected. The tool is not explosion proof and
can cause sparks.
227BDo not use the tool while standing in water.
2) 228BCheck the area and determine if the Inspection Camera is the
correct tool for the job.
Check the access points to the area.
Check if there is any electric power supplied to the area to
be inspected.