Filter
Top Products
Step 4: Inspect again with SensorScope
Inspect your sensor with the SensorScope to make sure all the large
debris has been removed.
Step 5: Apply SensorSolution and wipe with SensorWand
Remove one SensorWand from its packaging. Moisten one end of the
wand with two drops of SensorSolution.
Caution: Do not use more than two drops of SensorSolution. Using more than two
drops of SensorSolution may cause damage to your camera and its sensor. Two drops
will effectively break the bond that holds tougher debris such as organics and fi bers
to the surface of your digital SLR sensor and fi lter. Don’t touch the SensorWand tip
with your fi ngers. Oils may contaminate the SensorWand and your sensor surface.
Because SensorSolution is quick drying, we recommend that you do not moisten the
SensorWand until you are ready to start cleaning your sensor.
Once you have moistened the SensorWand (Side A) with two drops of
SensorSolution, place the wet end on the left side of your sensor. Tilt
the SensorWand as shown and gently wipe your sensor from left to
right. Then, tilt SensorWand back as shown and begin a second wipe
with the same moist end (Side A) from right to left.
Caution: Do not apply too much pressure. You may damage your sensor permanently
if too much pressure is applied. It is best to start with light pressure and increase
pressure as needed.
Wipe Sensor from left to right using side A
Wipe Sensor from right to left using side A
B
A
A
B
10