Elmo 1340 Digital Camera User Manual


 
8
Transfer the data from the SD card onto a device such as a PC to save a backup copy.
Malfunction of the product or repairs to it may cause the data saved in the SD card to be deleted.
If this product is used for longer than the warranty period, its performance and quality may
deteriorate due to the lifetime of its parts. To purchase replacement parts, consult the dealer from
whom you purchased this product or our branch/office near your location.
Battery precautions:
If this product is not going to be used for a long time, take the batteries out of the remote
control.
Do not use rechargeable batteries (e.g., Ni-Cd (NiCad batteries)).
Do not use new and old batteries or batteries of different types together.
Do not try to recharge or short-circuit the batteries.
When disposing of used batteries, follow the instructions of your local government.
Insert from one side and pay particular attention to the polarity (+/- directions).
Be sure to use AAA batteries.
• If any liquid from a battery leaks onto your skin or clothes, flush the area with clean water
immediately. If it gets into your eye, flush immediately with clean water and then contact a
doctor.
Do not burn, disassemble, change nor dispose of in fire. Doing so damages the insulation
materials which may cause heat generation, leakage, bursting or a fire.
Do not damage nor peel off the resin film on the surface of the battery.
About using microphones
Connecting microphones other than electret condenser microphones (microphones for PCs and
so on) could cause a malfunction to occur. If you are concerned about this product’s operating
noise when using the built-in microphone, we recommend using an external microphone.
About the audio input port
Do not connect any audio line-output devices such as a CD/MP3 player to the audio input port
when the Audio Selector is set to “Mic-in.” Audio input is a dual purpose port (microphone/line-in)
which supplies power when “Mic-in” is selected, adding external output devices (CD/MP3) may
damage them.
About the MIC IN/ AUDIO OUT cable
Before connecting the cable with the product, attach the ferrite core that is supplied with the
product to the cable as close to the connector of the product as possible.
(Example: Looping a cable through the ferrite core 2 times)
Menu / Icon
Some functions may not be set or operated depending on the mode or the menu / Icon settings
being used.
To the connector
of the product
Close