Filter
Top Products
- 4 -
Tilt lock screw
For locking the tilt after adjusting the image up/down
direction.
Pan lock screw
For locking the pan after adjusting the image
right/left direction.
Zoom ring
For adjusting the image size.
Focus ring
For adjusting the focus.
PUSH button
· Vertical sync. phase adjustment
To adjust the vertical sync. phase when using two or
more Line-Lock cameras, press the PUSH button
( ) or ( ) until images stop rolling.
However, it should be noted that this adjustment is not valid when the select switch is in such positions as
WB1: L, WB2: L and WB3: H.
· Manual white balance selector
When the white balance selector is set to MANU (shift change) in on the next page, the white balance
can be adjusted by using the PUSH button. This mode will prove effective under shooting conditions with
little variation in color temperature.
* When the white balance selector is set to MANU (shift change), the vertical sync. phase can not be
adjusted.
ALC LEVEL
For adjusting the image brightness.
Main body mount screws (2 pcs)
Screws located for mounting the main body to the metal fitting.
Caution: Both screws must be tighten to prevent the camera from falling.
Reinforce board
A board rotating together with the camera part.
* This board may interfere with the selector switch depending on the set pan direction. Slide
the board to avoid the interference with the selector switch. After this sliding, be sure to
8
9
A
B
C
D
E
10
E
D
8
9
A
C
F
D
B
10
B
F