Filter
Top Products
Sawgrass Technologies, Inc. SubliJet IQ
®
Getting Started Guide for the EPSON Stylus Photo 1280
8
6. Clean the area where the adhesive will contact the printer with the alcohol pad
provided. Let dry.
7. Pull the bottom piece of 3M Dual Lock Tape off of the support bracket, peel the
plastic backing and attach to the marked position. Firmly push down the entire
piece.
8. Slide the print head left and right, as far as it will go to ensure that none of the tubing
or any part of the QuickConnect system touches the interior of the printer.
9. When you are confident that the QuickConnect system will not interfere with normal
print head movement, push the print head to the far right into the parked position.
10. Mark the position for the rubber bumpers used to prop open the lid. The bumpers
should be far enough towards the back of the printer, to keep the lid from putting
pressure on the Acrylic Support arm. See Fig 9 and Fig 10.
The support arm may need to be shifted left or
right, up to a quarter of an inch, if the tubing
contacts any part of the printer. If the tubing
appears overly stressed when the print head is in
the far left position, move the support arm slightly
lef
t by pulling the 3M Dual Lock Tape connection
apart and reattaching. Make sure the 3M Dual
Lock Tape on the support arm is fully locked onto
the 3M Dual Lock Tape on the printer by applying
pressure to it and slightly twisting the support
arm back and forth.
Fig. 10
Fig. 9