Filter
Top Products
Sawgrass Technologies, Inc. SubliJet IQ
®
Getting Started Guide for the EPSON Stylus Photo 1280
13
Replacing an Empty Ink bag
1. Attach slide clamps to tubing, one clamp for each tube.
2. Move the slide clamp close to the female connector on the tubing of the ink bag to
be changed.
3. Slide the clamp so that it pinches the tubing closed.
4. Disconnect the connectors by pressing the silver button on the female connector.
Be aware the connectors may drip slightly when removed. Replace the empty ink
bag with a fresh one.
5. Loosen the clamp so that it hangs loosely on the tubing.
Transporting the printer with QuickConnect
1. To transport the printer with the QuickConnect, ensure the printer is off and in the
parked position (printhead is all the way to the right and will not move).
2. Starting with the black tube, move the slide clamp close to the female connector
and slide the clamp so that it pinches the tubing closed. Repeat this for all tubes.
3. Once the tubing is pinched off it is safe to transport the QuickConnect. Just
remember to loosen the clamps when you’ve arrived at your destination to allow
for the flow of ink again.