Filter
Top Products
EPSON PhotoPC 500
The number on the control panel indicating pictures
remaining increases to show your camera’s expanded
capacity.
With the expanded memory, you may notice a delay between
the time you press the shutter button and when the camera
beeps. To reduce this delay, press the button down halfway
until you are ready to take the picture, then press it down the
rest of the way.
2. Grasp the cover and pull away.
3.
Place the module into the socket, as shown below. Align
the side of the module that has two notches with the
socket end nearest the small black lever. (See the
illustration under “Removing a PhotoSpan Memory
Module” for the location of the lever.)
4.
Press down on the module until it snaps into the retaining
clips at the side of the socket. Do not force the module. If
it does not seem to fit, make sure that you have inserted it
correctly.
5.
Replace the cover on the camera body. It should snap into
place.
Removing a PhotoSpan Memory Module
Follow these steps to remove the memory module:
CAUTION
Do not remove and install the module repeatedly. Doing so may
cause a bad connection or may damage the memory module.
Turn the camera off and remove the memory module cover.
Press the lever on the side of the memory module socket to
raise the module slightly out of the socket.
Grasp the edges of the memory module and work it up and
out of the socket. Be careful not to touch the metal parts of
the module.
Replace the memory module cover.
Digital Camera
10/96
EPSON PhotoPC 500 - 7