9
• Fit the ends of a support tube down through the hole in each
ball drop.
• Push the support tube down so that it is completely into the groove
in the base-ramp assembly.
10
• Insert two .625" screws into the support tube and tighten.
11
• Fit the ends of the other support tube down through the hole in each
end of the base-ramp assembly, as shown.
• Push the support tube down so that it is completely into the groove
in the base-ramp assembly.
8
• Insert two .625" screws into the ball drop and tighten.
Support Tube
Support Tube
Assembly
5