Filter
Top Products
21
• Insert a 1.25" screw through the ends of each arch and tighten.
22
• Lift the plug on the ball. Inflate the ball and quickly close the plug.
Note: Do not over-inflate the ball.
• Insert the “T” end of the ball strap through the slot in either arch.
Pull the strap to be sure it is secure.
20
• Align the ends of the arches with the tops of the ball drops. Fit the
arches over the support tubes, as shown. Push the arches down
firmly to “snap” them into place.
Hint: The arches are designed to fit one way onto the tops of the
ball drops. If the arches do not fit onto the ball drops, try turning
them around!
Assembly
“T” End
8