13
• Turn the base-ramp assembly upright.
• With the arcade-slide assembly facing down, fit the knobs into the
grooves in either end of the base-ramp assembly.
14
• Fit the bracket onto the base, so that the end of the support tube
inserts through it, as shown. Push the bracket down firmly to “snap”
it into place.
• Insert two .625" screws into the bracket and tighten.
12
• Insert two .625" screws into the support tube and tighten.
Bracket
Arcade-Slide
Assembly
Groove
Base-Ramp
Assembly
Knob
15
• Fit the ball wheel into the groove on the base, as shown.
Ball Wheel
Groove
Assembly
6