Filter
Top Products
FS-2/2E Studio DTE Disk Recorder User Guide
15
Introduction
1.10Replacing the Power Module Fuse
The power module of the FS-2/2E contains a protective fuse.
To replace the fuse do the following:
1. Turn off the FS-2/2E.
2. Locate the power module on the rear of the unit. It is indicated as AC In.
3. Detach the power cord from the power module.
4. Locate the small recess on the top of the power module above the power
switch.
5. Use a small tipped standard screwdriver to pop open the fuse door.
6. Once open, slide the white fuse carrier out of the unit.
7. Replace the fuse with a 1.6 amp 250V slow blow fuse.
8. Reassemble the fuse carrier and slide it back into the unit.
9. Replace the fuse box door.
10. Re-attach the power cord.