Filter
Top Products
vi
Do not use the scanner if there is a
strange odor.
Do not use aerosol sprays near the
scanner.
Do not install the scanner on
unstable surfaces.
Do not place heavy objects or stand
on top of the scanner.
Firmly insert the power plug.
Do not use the scanner immediately
after moving it from a cold place into
a warm room.
Before moving the scanner,
disconnect the power plug from the
power outlet.
Protect the scanner from static
electricity.
Disconnect the power plug from the
power outlet when the scanner is not
used for a long period of time
If you detect excessive heat coming from
the device or detect other problems such as
smoke, strange smells or noises,
disconnect immediately the power plug in
order to turn out the scanner. Make sure
that any smoke coming from it has stopped,
before contacting the store where you
bought the scanner or an authorized
FUJITSU scanner service provider.
Do not use any aerosol sprays or alcohol
based sprays to clean the scanner.
Dust blown up by strong air from the spray
may enter the inside of the scanner. This
may cause the scanner to fail or
malfunction.
Sparks, caused by static electricity,
generated when blowing off dust and dirt
from the outside of the scanner may cause a
fire.
Make sure that the scanner is installed on
a flat, level surface and that none of its
parts extend beyond the surface top, such
as a desk or table. Do not install the
scanner on unstable surfaces. Install the
scanner on a level surface that is free of
vibration to prevent it from falling.
Install the scanner on a strong surface that
will support the weight of the scanner and
other devices.
Do not place heavy objects on the scanner
or use the scanner's surface top to
perform other work. Improper installation
might cause injuries and equipment
failure.
Firmly insert the power plug as far it can
go into the power outlet.
Do not use the device immediately after
moving it from a cold place into a warm
room. Condensation may occur, which
might lead to scanning errors. Let the
device dry about one or two hours before
you use it.
Do not move the scanner with the power
and interface cables connected as this can
damage the cables, which can later cause
fire, electric shock as well as injury.
Before moving the scanner, be sure to
disconnect the power plug from the power
outlet, and all other data cables.
Make sure that the floor is free of any
obstructions.
Install the scanner away from strong
magnetic fields and other sources of
electronic noise. Also, protect the scanner
against any static electricity, which can
cause the scanner to malfunction.
When the scanner is not going to be used
for a long period of time, be sure to
disconnect the power plug from the power
outlet for safety.