Filter
Top Products
Sharing and printing images 37
Note The camera uses a USB connection, so you do not
need to turn the computer off when connecting or
disconnecting the camera.
To connect the camera to a Macintosh computer
1 Make sure the camera is turned off.
2 Plug the smaller end of the USB cable (supplied) into the
camera.
3 Plug the flat end of the cable into any USB port on your
computer.
Note When the camera is connected to your computer,
only the switch operates. The other
camera buttons do not respond.
Unloading images to a Macintosh computer
Unloading images is the process of copying images from the
camera to your computer. If you have a CF memory card installed
in the camera, images will be copied from the CF memory card to
the computer.
You can unload images from your camera in one of two ways:
automatically or by mounting the camera as a disk drive. The
automatic unload procedure is the preferred method.
Tip To conserve battery power, you can use an AC
power adapter (optional) when you are unloading
images to your computer.