Filter
Top Products
HP photosmart 318 User Guide60
Error messages
If an error message appears on the image display, try one of the
following solutions.
The computer
does not
recognize the
camera and
the automatic
image unload
does not
start.
The camera is not
configured correctly
for the type of
computer you have.
Open the Setup menu and check the
PC Connect Mode setting:
• If you are using a Windows
computer, make sure PC Connect
Mode is set to Digital Camera.
• If you are using a Macintosh
computer, make sure PC Connect
Mode is set to Disk Drive.
You have not taken
any new pictures
since the last time
you unloaded
images to your
computer.
When you unload images to your
computer, the images are still stored in
the camera until you delete them. If you
take new pictures and then unload
images again, the automatic unload
software ignores the old images. If you
have no new images in your camera
when you connect it to the computer, the
automatic unload does not take place.
Your Macintosh
computer has an
older version of OS
8.6, which does not
support USB mass
storage.
Go to the Support section of
www.apple.com and download the USB
Mass Storage Support (version 1.3.5)
update.
Error
message
Possible cause Solution
BAD CF CARD! The CF memory card is
damaged.
Reformat the CF memory
card or replace the card.
BATTERIES ARE
TOO LOW FOR
LIVE VIEW
Power in the batteries is
insufficient for you to
preview your pictures.
However, you can take
pictures or review your
images.
Press the button to turn
the image display off and use
the viewfinder to frame your
pictures.
Problem Possible cause Solution