Filter
Top Products
Sharing and printing images 33
To connect the camera to a Macintosh computer
1 Make sure the camera is turned off.
2 Plug the smaller end of the USB
cable (supplied) into the camera.
3 Plug the flat end of the cable into
any USB port on your computer.
Note When the camera is
connected to your
computer, only the power control operates. The
other camera buttons do not respond.
Unloading images to a Macintosh computer
Unloading images is the process of copying images from the
camera to your computer. If you have a CF memory card installed
in the camera, images will be copied from the CF memory card to
the computer.
You can unload images from your camera in one of two ways:
automatically or by mounting the camera as a disk drive. The
automatic unload procedure is the preferred method.
Tip To conserve battery power, you can use an HP-
approved ac power adapter (optional) when you are
unloading images to your computer.
To automatically unload images to a Macintosh computer
1 Connect the camera to your computer by using the USB cable.
2 Turn on the camera.
The status LCD displays PC to indicate the camera is
connected to a computer.