Hitachi DZ-GX5100SW Camcorder User Manual


 
English
133
Card error has
occurred.
Formatting is not
complete.
The card may be damaged: Use another card.
24
Card error has
occurred. Keep card
inside & restart.
Card error could have occurred during editing of scenes. Turn off
the DVD video camera/recorder with the card being used inside,
connect the AC adapter/charger, and then power the DVD video
camera/recorder again.
25, 30
Card full. Delete unnecessary stills and try the card, or use another card. 78, 149
Card is not formatted.
Format the card now?
Was the card formatted on PC? When using the card on this DVD
video camera/recorder, choose “YES” and format it.
98
CHECK DISC A disc unusable on this DVD video camera/recorder may have
been inserted or the disc may be damaged.
Make sure that the type of disc is correct, and make sure that the
disc is not write-protected.
24, 99
Control Information
Error.
Mismatch may occur between the recorded image and scene
information.
Update the control information.
100
Use another disc.
See *3 and *4 on page137.
9, 23
COPY PROTECTED The video signal input to this DVD video camera/recorder may be
copy-guarded.
Some prerecorded video materials, such as movies, are guarded
against copying.
Copy-guarded materials cannot be recorded on this DVD video
camera/recorder.
109
DISC ACCESS The recorded scene is being stored on disc. 40, 41
This DVD video camera/recorder is verifying whether the correct
disc has been inserted.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
37
DISC ALMOST FULL The remaining free space of disc is less than one minute for
video: Delete unwanted scenes, or use another disc.
78, 148
Disc error has occurred.
Finalizing is not
complete.
Disc error occurred during finalising, and finalising failed.
Replace the disc.
See *3 on page 137.
101
Disc error has occurred.
Format the disc now?
Has the disc been initialised on PC? Has initialising the disc on
PC been interrupted?
Choose “YES” and initialise the disc when using it on this DVD
video camera/recorder. Initialising the disc will erase all data on
it.
See *2 on page 137.
98
Disc error has occurred.
Formatting is not
complete.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before
reusing it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
9, 98
Message Cause & Troubleshooting
Reference
page