Filter
Top Products
IDENTIFICATION AND OPERATION OF CONTROLS
32
• These buttons are used for title making buttons when the "TITLE" button is pressed.
(See "TITLE RECORDING" on page 34.)
• These buttons may be also used to set the date and time during pause (stand-by)
mode. (See "DATE/TIME SETTING" on page 22.)
Diagram of Camera
Cassette Holder
Press "EJECT" button to open the cassette holder. Be aware of the cassette direction
when inserting.
NOTE: Power source must be connected to open the cassette holder.
Clock Battery Compartment
Pull the battery holder and install the clock battery (provided).
"DC IN 9.6V" Jack
When using the AC adaptor/charger (provided) or the car battery cord (optional),
connect this jack and the "DC OUTPUT" of the AC adapter/charger or the car's cigarette
lighter socket.
"MIC MIX (ON/OFF)" Switch
This switch lets you add additional comments (or music) to a tape while you are copying
a tape from your camera/recorder onto another VCR.
"AV OUT" Jack
Connec the video/audio output cord (provided) to this jack and to the audio and video
inputs of your TV/monitor receiver. You may also connect the RF converter unit to this
jack and your TV receiver.
"AV IN" Jack
Use this connector jack when you want to send signals from another device into your
camera/recorder for recording.
"Record Start/Stop" Button
This button is used to control the camera/recorder. When the "POWER" switch is set to
the "CAM" position, pressing this button starts the tape to begin recording. "REC"
appears in the viewfinder.
When this button is pressed again, "PAUSE" appears instead of "REC" and the tape
stops and the camera/recorder enters the record/pause (stand-by) mode.
Power Zoom Switch