JVC GR-AXM210 Camcorder User Manual


 
46 EN
USER MAINTENANCE
After Use
1
Set the Power Switch to “POWER OFF” to turn off
the camcorder.
2
Open the LCD monitor to an angle of over 60
degrees. Slide EJECT to open the cassette holder, then
remove the cassette.
3
Close and lock the cassette holder by pressing PUSH.
4
Close and lock the LCD monitor.
5
Slide BATTERY RELEASE to remove the battery pack.
6
Turn the LENS COVER Open/Close Ring to close
the lens cover.
Cleaning The Camcorder
1
CLEAN EXTERIOR
Wipe gently with a soft cloth.
•Put cloth in diluted mild soap and wring it well to
wipe off heavy dirt, then wipe again with a dry
cloth.
2
CLEAN LCD MONITOR
Open the LCD monitor and wipe it gently with a soft
cloth. Be careful not to damage the monitor. Close
the LCD monitor.
3
CLEAN LENS
Blow it with a blower brush, then wipe it gently with
lens cleaning paper.
4
REMOVE EYEPIECE
Turn the eyepiece counterclockwise and pull it out.
5
CLEAN VIEWFINDER
Remove dust using a blower brush.
6
RE-ATTACH EYEPIECE
Re-attach the eyepiece and turn it clockwise.
Remove.
PUSH
LENS COVER Open/Close Ring
EJECT
Set to “POWER OFF”.
BATTERY RELEASE
NOTES:
Avoid using strong cleaning agents such as benzine or alcohol.
Cleaning should be done only after the battery pack has been removed or other power units have been
disconnected.
Mold may form if the lens is left dirty.
When using a cleaner or chemically treated cloth, refer to the cautions that came with it.
When removing the eyepiece, be sure to hold the viewfinder securely.