Filter
Top Products
EN49
INDEX
Indications
1 Cassette Warning/
Tape Remaining Time ..........................
੬ pg. 17
When no cassette is inserted: the cassette (
)
warning blinks.
When the Erase Protection tab is not in the position
that allows recording: the cassette (
) warning
lights. Otherwise, the tape remaining time is
displayed and the tape remaining time warning
blinks when the tape is about to reach its end.
When the Power Switch is set to “PLAY” and a
tape is loaded: the cassette (
) mark is displayed
regardless of the Erase Protection tab’s position.
2 Recording Mode (SP/EP) Indicator ........ ੬ pg. 12
3, 7 Program AE Indicator ...................... ੬ pg. 26
Displayed at
3 for approx. 2 seconds when
Program AE with special effects is switched from
one mode to another by pressing P.AE., then only
the indicator remains at
7.
3, 8 Fade/Wipe-Standby Indicator .......... ੬ pg. 25
Displayed at
3 for approx. 2 seconds when the
Fade/Wipe is switched from one effect to another
by pressing EFFECT, then only the indicator
remains at
8.
4 Tape Length Indicator .......................... ੬ pg. 12
5 Zoom Indicator Bar ............................. ੬ pg. 20
Zoom Level Indicator
Approximate Zoom Ratio
6 Recording Indicator ............................. ੬ pg. 16
9 Picture Stabilizer Indicator ................... ੬ pg. 22
0 •Interval Timer/Recording Time
Indicator ...........................................
੬ pg. 38
•5 Sec. Rec Mode Indicator ................
੬ pg. 21
(GR-AXM210 only)
! •Bright Level Indicator ........................ ੬ pg. 41
•Speaker Volume Indicator .................
੬ pg. 41
@ Instant Title Display ............................. ੬ pg. 29
# Date/Time Display ............................... ੬ pg. 28
$ Battery Pack Remaining Power Indicator
Changes as follows according to the battery
pack’s remaining power level:
“
”. When the power is
almost gone, the indicator “
” blinks (battery
power warning), then the unit shuts off. Replace
the battery pack with a fully charged one.
Note: The symbol containing 3 darkened squares —
— does not necessarily mean that the battery
pack is fully charged.
% Focus Indicator .................................... ੬ pg. 35
^ Exposure Control Level Counter ........... ੬ pg. 33
& White Balance Mode Indicator ............ ੬ pg. 36
* •Record–Standby Mode Indicator ....... ੬ pg. 16
•Lens Cover Warning:
LENS COVER ....................................
੬ pg. 17
( Clock Battery Warning
Blinks for approx. 10 seconds when the power is
turned on. This display also blinks when the clock
(lithium) battery is either not installed or has
discharged. Install or replace the old battery with
a new one (
੬ pg. 10).
) •Tape End Display: TAPE END ............ ੬ pg. 17
Appears when the end of the tape is reached
during playback, recording or fast-forward.
•Condensation Warning:
When this indication appears, all functions
except tape eject and power on/off are disabled.
Turn the unit off (without removing the power
source) for a few hours, and when you turn it on
again the indication should disappear.
•Head Clog Warning:
Appears if dirty heads are detected during
recording. In such a case, use the optional
Cleaning Cassette. If, after using it, the problems
still exist, consult your nearest JVC dealer.
NORM
S
INDEX
20X
FINE 10
30MIN
SP
T30
15S
5S
BRIGHT
DEC 25. 99
AM 11
:
45
:
18
MERRY CHRISTMAS
LENS COVER
TAPE END
PAUSE
FADER
2
REC
01
1X
6
7
8
9
0
@
#
!
)
(
&
^
*
%
$
5
432 1
a
b