Filter
Top Products
E-16
ON
OFF
1234
2. Preparation Before Shooting (continued)
Microscope
Adapter
Connecting Through Analogue Output
Caution
● Perform this when the devices are off.
● Use the 1/3-inch, C mount adapter for the micro-
scope adapter.
Notes
● Connect a switch between PIN 2 (TRIG) and PIN
3 (GND) of the [TRIGGER] terminal. If this switch
is set to [ON], a trigger will freeze the input image
to the camera and capturing of images synchro-
nized with the trigger is possible.
● Ensure to attach the supplied clamp filter to the
cable connected to the Analog Signal Output
[RGB, Y/C, SYNC OUT] terminal in order to re-
duce unwanted electromagnetic emissions.
☞ Page 48
Images taken by this unit can be output to monitor, colour video printer or other devices.
1.
Connect device such as the Colour Video Printer
to this unit’s [RGB, Y/C, SYNC OUT] terminal.
2.
Set the switches located at the side of this unit.
● Setting Switch 2
Set this switch to [ON] (upper side) for Y/C
output.
Set this switch to [OFF] (lower side) for RGB
output.
● Setting Switch 3
Set this switch to [ON] (upper side) if sync sig-
nal is to be superimposed onto the Green (G)
channel of the video signal.
☞Page 10 ‘9 Function Setting Switch’
Example: During RGB output
3.
Switch on the power of this unit.
Trigger Switch
AC Adapter
‘Connecting the
Power Supply’
(Page 18)
Colour Video Printer etc.
Monitor
REMOTE
CONTROL
UNIT
RM-LP55
RM-LP57
BNC CABLE
AC IN
AA-P700
[TRIGGER]
[REMOTE]
[DC IN]
[VIDEO OUT]
[RGB, Y/C, SYNC OUT]
VC-451-2
R
G/Y
B/C
SYNC
VBS
Switch 3Switch 2
AC ADAPTER AA-P700
AC ADAPTER AA-P700
ON
OFF
POWER
POWER
POWER
ALARM
ALARM
SHEET
SHEET
PAPER
PAPER
DATA
DATA
OPEN
OPEN
CP700DSA
CP700DSA
MITSUBISHI
MITSUBISHI
ONLINECOPY & CUTPAPER FEED
]
LENS
DV
VIDEO OUT
TRGGER
REMORT
POWER
RGB
,
Y/C
,
SYNC
OUT
DC IN
SEE INSTRUCTION MANUAL
SETMENU
Clamp filter
(accessories)